sport

DIY Guide: Make Your Own Soccer Pennant Banner

Advertisement5

If you are looking for a DIY method to create a personalized soccer pennant, you have come to the right page. Ideally, the whole process will be easier if you use a real pennant as a guide. This will make it easier for you to get the measurements. So let’s start and go through the practicality of the project.

As stated before, make sure you get a real product for help. For example, you can also buy a yardstick of felt. Then you can release the number of cuts. Ideally, you can cut a number a little smaller than the previous number for a layered look. In fact, the idea is to make sure that the numbers are the right size for the pennant. If you can get the shape right, you can get the job done in the first step. Then the seam should be done.

Also make sure to sew the top and sides of a large rectangle to the left side of the pennant, which will make a rod pocket. This rod pocket will be used for the ankle.

Ankle rods are not expensive. You can get each piece for less than a dollar. So, the cost won’t be a problem if you are worried about your budget. It’s best to get a few extra dowel rods in case you make a mistake during the process. You can use the spare ankle rods in this situation.

You can use a tool like a branch pruner to cut them into two pieces. The one on the far right is for your private use. If you are doing this for your daughter, be sure to keep the length short. One of the benefits of shorter ankles is that your daughter can maintain better control over them.

You need to make sure that the peg is securely fastened in the pocket, which is necessary to prevent the peg from flying towards the visitors’ stands the first time it is shaken. Be sure to mark the end points of the rod pocket. You can use a Sharpie marker or a finger grip.

The next step is to get a piece of duct tape (it should be 6 inches long). Once you have it, you need to cut it in half. This will give you two small pieces. Starting a little above the marked point, you should wrap the ribbon and then add the other piece on top.

Here it is important to note that the outer bands tend to function as a plug. Therefore, the outward facing strip will not slide down or up. On the other hand, the inner band provides just the right grip to the rod pocket. That way you won’t lose your pennant. In addition, the grip should not be so strong that the withdrawal of the ankle becomes impossible at the end of the season. After all, you must also use the same pennant next year.

So, this is the whole DIY procedure to make your own soccer pennant. The achievement will be easier if you follow the guidelines given in this article.


Source by Shalini M

Advertisement6

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button